Categories
printing

Printing to a NON postscript Fuji Xerox printer

xerox

I have a Docucentre C4350 Fuji Xerox printer which does not have postscript installed. The normal drivers from Fuji assume you have Postscript installed. Here’s how to get the non-postscript printer going.

1. You need to install a special non-postscript driver.  I have searched everywhere and I can’t find where I downloaded it from. They were from a fuji Xerox site in Singapore, they are not available from the USA site that I can find.  Here is version 1.3 for you to download:  fxmacprnstd1112am105iml.dmg

Update– Fuji Xerox have released a newer version 1.5  You can download it from fuji here.

Update 2:  The version 1.5 drivers have been upgraded again and they are now here. You want the version that says “Driver Type: Non PS.”

2. Go to System Preferences, Printer and add a new printer (‘+’ button).
Choose ‘IP Printing’ and LPD and enter the IP address of the printer.

Xerox printer

It will find your printer automatically and it will choose the right driver (Eg FX Docucentre-II C4300 v3016.103 PS’ above). This will NOT work with a non-Postscript printer!

You need to Choose ‘Select Software’ then choose the ‘FX Print Driver for Mac OS X v1.3’ that you just installed.

Screen Shot 2014-01-01 at 3.41.08 pm

 

This works on OSX 10,7 10.8 and 10.9 (Mavericks).

You need this newer version for OS 10.10 and 10.11

 

7 replies on “Printing to a NON postscript Fuji Xerox printer”

Thank you very very much, finally found this solution for my network printer 3005 and 4070 fuji xerox. I tested this method and it works fine for me.

Thanks. Such a relief after hours of trouble shooting. Our docu-centre c2265 loves this and now works.
It was a bit odd in my head searching for a driver that isn’t printer specific (ie. model name not in Driver name)

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.